IMA Question

[rmmagow]

A Cisco newbie but experienced Nortel. I've got a Cisco 3745 running IOS 12.02 (? but I do know 12.x). I have an IMA ATM defined, 4 T1's. I know the command "sho int atm3/ima0.1" to check the overall status of the circuit but I need someone to tell me a command I can run that could show me the status of an individual T1 in the ima group. I had the phone company tell me one of my T1's was down and couldn't figure out a way to check it once they informed me it was fixed. The ima kept running and I didn't see any error conditions. Any guidance is appreciated.
Thanks.

 

[eurobadger]

Hi

IMA FAQs on CCO.

http://www.cisco.com/en/US/tech/tk39/tk356/technologies_q_and_a_item09186a0080111162.shtml

EB

 

[l1carter]

HI,

I have not done this for a while but I think you can do a show controller atmX/X which would be the individual T1 Port on the 4-Port IMA Module.

 

[rmmagow]

The Sho controller command was perfect. Thanks. Found another, sho ima int, gives a real short view of what all is up or down.