Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

I need to allow only interanal & 800 number dialing on a few phones

Status
Not open for further replies.

Bonzai66

MIS
Feb 24, 2005
15
US
I have about 15 phones which I need to setup for training, on my Option 61C...I need them to be able to call either 800 numbers or a specific 800 number would be good, and internal 4 digit extentions, but nothing else outside. It's been 4 years since I last touched a merdian switch at my old job, and I can't remember where to start. PLEASE HELP !

Thanks in advance..

Buck
 
hope you've got a minute, fre in cls should be enough, if the 1800 number are spn's, if not you'll need to do some magic in loads 90 and 86.. read the post on ncos setting, i just wrote a fair def of the same problem

john poole
bellsouth business
columbia,sc
 
i had to crack up when I read this post and saw Bonzai66 was asking about inter-anal dialing! sorry to poke fun at you Bonzai but you have to admit it's kind of funny.
On a more serious note, I think I once set up a phone in my office to dial only internally and ONE specific outside #. I'll double-check my programming and see if I can remember what I did to make this work and I'll post back. Otherwise, as JohnPoole already said, it's going to take a little longer than a minute.
 
Yes yes, ya know I didn't even notice until I read the responses what I had typed...I'd say I FAT Fingered the keyboard, but that might make it worse;-) ...Anyway I appreciate the responses, and yes it is funny, and I'm pretty sure Illegal too:-0

Anyway after I asked this question I searched thru for about 3 hours and read some articles by John Poole and Others, and then I went into the Switch, setup SSC's and made a new SSC with an NCOS of 7 and placed the one number in that Speed Call List, which enables me to bypass the NCOS for that set and leave it CTD but still dial that number and INTERNAL 4 digit Extensions only. Also only program that Feature on certain sets. I can tell this group is going to be invaluable in getting myself back up to speed.

Thanks again to all.

Bonzai'
 
That's the Kind of Calling you do when you have your head up your butt :-0 It also gives new meaning to the use of Phone Wipes.

Bonzai'
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top