from a time ago i cant connect to some corebuilder 9000 (3com) slots. this started when i connected to a slot, reached the SNMP submenu and the session was blocked, so i broke the telnet, and started again. But now i cant connect anymore to some slots.
These are the Operational Version: v2.1.0 and Boot version: v2.0.1 of this switch.
My switch is compounded of two 9-port 1000sx cards, two 36-port 10/100 Mbps cards and one Layer-3 card.
Do you have any idea, how can i connect again to all slots.
I haven´t tried to reset switch 'cause is on service 24 hrs a day. but if it is not other way, then i'll do it.
These are the Operational Version: v2.1.0 and Boot version: v2.0.1 of this switch.
My switch is compounded of two 9-port 1000sx cards, two 36-port 10/100 Mbps cards and one Layer-3 card.
Do you have any idea, how can i connect again to all slots.
I haven´t tried to reset switch 'cause is on service 24 hrs a day. but if it is not other way, then i'll do it.
