How To: Toll Calls and Routing Tables?

[100mbs]

Hi I need to change the routing tables in my Definity G3.V9.

All of our local toll calls were going over our long distance lines and I need to change them so they go over our local carrier lines.

My Local carrier sent me their Routing table that I need to change in my switch. It looks something like this.

APTOS ZONE USAGE MEASUREMENT REPORT (ZUM + TOLL) 03/07/02

ZONE1 ZONE2 ZONE3 TOLL

DIST DIST DIST DIST
NPA NXX AREA NPA NXX AREA NPA NXX AREA NPA NXX AREA
--- --- ---- --- --- ---- --- --- ---- --- --- ----
619 123 LAJL 760 206 SNMC 619 904 LVTA 619 456 SNDG
760 789 ENCT 760 145 CRLS 619 321 POWY


How do I change the routing pattern in my switch so all of my local toll calls are being sent over my local carrier lines? Do I just change the route patterns or do I have to change the ARS Toll Tables? Also from the table that was sent to me, do I actually have to enter any data or change the routing around?

Thanks in advance for your help.

 

[Dustinn3]

You'll have to change the route pattern on each number to go over your local carrier's lines. Just do a ch ars ana followed by the area code you want to change, then change the route pattern to your lec's trunk group and the call type to hpna.

 

[Phoneman2]

Do your local toll calls going out by dialing a one before the area code, if so thats the ARS number you need to change. 1619, 1760 Look!!! New Buttons
Same amount of time!

Thanks All Phoneman2