How to setup queries to my PBX using SNMP?

[oscar01]

I have CM6.3 and would like to setup queries using SNMP to check the status of certain services every few minutes. How would I set this up?

Thanks

 

[montyzummer]

You can set up snmp traps from within the smi web interface ( v ip of your proc r browse to it) you can also depending on your snmp tool interrogate logs from CM , CDOM etc , in the first instance check out the web pages and all will become obvious

APSS (SME)
ACSS (SME)
ACIS (UC)

 

[montyzummer]

You can set up snmp traps from within the smi web interface ( v ip of your proc r browse to it) you can also depending on your snmp tool interrogate logs from CM , CDOM etc , in the first instance check out the web pages and all will become obvious

APSS (SME)
ACSS (SME)
ACIS (UC)