How to set time for AFWDNO feature H4K ? 1

[jarmac]

Hello

I can not find a way how to change time for activation forward with no answer feature. AFWDNO

It is possible to change it ?

regards
jarmac

 

[sbcsu]

The delay in seconds before a call is forwarded to the divert on no answer system wide is in CTIME CP1 NOANSADV (No Answer Advance)
This is a system wide timer and is counted in seconds not rings.
To see the current value: DIS-CTIME:CP1;
To change the current value: CHANGE-CTIME:TYPESWU=CP1,ANSADV=X; (Where X is the time in seconds from 3 to 3600)
The above may not apply to all HiPath 4000 as the timers in the older versions were not split into CP1, CP2 etc.

To change a divert on no reply time individually per extension then that is in ACTDA
ADD-ACTDA:TYPE=STN,STNO=xxxx,FEATCD=VARRING,RNGTIME=z; Where z is ringtime 0 to 60 seconds.
This individual ring time only works on newer versions of software.

 

[donb01]

I did not know that was an option for individual phones! Thanks.

Don Bruechert, Voice Comm Analyst II
CareTech Solutions @ Holy Family Memorial
Manitowoc, WI, USA

 

[sbcsu]

Handy when testing voicemail diverts etc. to change it down to 2 seconds.
Not sure how to delete the individual timer, maybe change it to zero ?

 

[donb01]

It might be either DEA-ACTDA or DEL-ACTDA like all the other ones. I can never remember which on it is and usually end up doing the wrong one first!

Don Bruechert, Voice Comm Analyst II
CareTech Solutions @ Holy Family Memorial
Manitowoc, WI, USA

 

[gkreg]

hi

just add-actda again for the timer of forwarding per ext. change the varring 20 for 5 rings then the call will transfer automatically

 

[sbcsu]

OK - just to confirm - to cancel the Individual Timer then -
ADD-ACTDA:TYPE=STN,STNO=XXXX,FEATCD=VARRING,RNGTIME=0;
Phone will revert to the overall system timer.

 

[jarmac]

Thank you all for answer.

Best regards
jarmac