How to look at more than 4 digits on a PRI "Tie" connection

[viper222]

OK, I started this on a different thread, but I thought I had different problem, so since it is basically a totally different issue, I am starting it here, and my old thread will point to this.

I have a audiocodes gateway that is tie'ing a IVR system to my Nortel Opt 11. I have CDP setup and I have the trunks built as DID and the DCH is setup as NI2. If I try to set it up as TIE for the trunks, my route wants CallByCallRouting and I don't have any clue how to do this.

AS IT SITS NOW, I can complete calls from the Nortel to the Gateway unit, and it works perfectly.
I can complete calls to an extension from the Gateway unit to the Nortel extensions and that works perfectly.
If I build an ACDN and forward it to an offsite number and have the Gateway call that extension, it goes offsite perfectly.
The problem is, when I have the Gateway call a number, 918005551212 or any number, it the Nortel only sees the last 4 digits. I can dial 5555577771212 and it will go to 1212 I can dial 431212 it will go to 1212,I can dial 95551212 and it will go to 1212.

So, what am I missing? Does anyone have a print of their route and maybe a trunk that they are using that is allowing this to work??

I do know it isn't my TARG/TGAR and not my NCOS.