Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to connect 403 to 406 through ethernet?
- Thread starter 5ascent0
- Start date
GettingIPO
IS-IT--Management
Are you trying to create a VoIP Link between the 2 Units using your ethernet lan ports?
GettingIPO
IS-IT--Management
Create a new line on each unit, on the VoIP tab set the opposite units IP address as the gateway, tick and enable voice networking and select H450 protocol. Please ensure that your Router between the 2 sites has QoS enabled.
I am assuming this requestes ties back to your previous request for a solution on the company moving. Remove the users from the existing 406 database that are moving onto the 403 and add them on there. Because you have enabled the voice networking it will automatically do the number routing on internal calls ie make it seamless. You should be able to leave your incoming call routes as they are.
I am assuming this requestes ties back to your previous request for a solution on the company moving. Remove the users from the existing 406 database that are moving onto the 403 and add them on there. Because you have enabled the voice networking it will automatically do the number routing on internal calls ie make it seamless. You should be able to leave your incoming call routes as they are.
- Thread starter
- #5
No, I did not have a VCM1 in the 403. Thanks for the insight. I will have one shipped overnight. In the meantime I have a VCM 10 I can temporarily use. I don't need any licensing other than PMPro user licenses, do I? I can just point the 403 to the license server that the 406 is using.
Nope, sorry. You will either have to buy additional PMPro licences (and another dongle) for the temporary 403 site or have them do without until they re-merge. Didn't realise on the other thread you were using PMPro or would have mentioned it. YOu're OK for the VMPro though, no extra licences required there.
BTW there is no such thing as a VCM1, I think you mean a VCM5.
Peter
BTW there is no such thing as a VCM1, I think you mean a VCM5.
Peter
NEVER be scared to state the obvious, often it is the minor detail being missed that causes all the hair tearing!
(I spent nearly an hour today trying to debug a Voip Link because I Typed the wrong IP address. AGGGGGHHH :-( )
Go on peter have a good gloat
(I spent nearly an hour today trying to debug a Voip Link because I Typed the wrong IP address. AGGGGGHHH :-( )
Go on peter have a good gloat
- Status
Similar threads
- Locked
- Solved
