How do I add a subinterface to a VLAN on c805 running 12.3(16)?

[ixleplix]

Hi All,
Is this possible with the C805?

from enable mode I type:
config t
int e0.1
ip address x.x.x.x 255.255.255.0

and get this response:
% Configuring IP routing on a LAN subinterface is only allowed if that subinterface is already configured as part of an IEEE 802.10, IEEE 802.1Q, or ISL vLAN.

Fine. I expected that. But for the life of me I can't find the command to add the subinterface to the VLAN. On a c1700 or c1800 series I'd use this command:

encapsulation dot1q 1 native

And then I'd assign the IP address...but apparently that command isn't supported on the 805.

So, is there any way to do this?

Thanks
Roland


*****************

What's ADD again?

 

[ADB100]

VLAN tagging isn't available on the 805. You need at least a FastEthernet interface for 802.1q trunking.

HTH

Andy

 

[ixleplix]

Thanks. Now I can stop beating my head against the wall.

Roland


*****************

What's ADD again?