how could I programme an analogue m

[md110user]

how could I programme an analogue modem with 8-ports on 2600-router series.

 

[StarTAC]

to do what, dial out, accept calls, or both..?..

good luck..

 

[md110user]

I need to make a dial in to the router from out side and inter to the local LAN,

 

[NewbieGirl]

You have to enter in the intilization strings for autoanswer into the modem. Hook the modem to the console port on the router (DB25-RJ45). Cisco has a technotes on How to.. Thanks,
Danielle

 

[md110user]

hi
I mean an analogue module which is insert on slot number one on the router :2610.

How could I programme that module which contains 8-ports. the purpose of that module is to enable a remote adminstrator to enter to the LAN and access the sources on that private LAN.

 

[tschouten]

On the NM-8AM and NM-16AM analog modem network modules, the interfaces are addressed as

interface async <line number>

As for configuring them they aren't too hard to use.

Here this site should help you out a little. It has dialin configuration examples and links to dial-out as well as configuration link if you don't know any of the commands. Hope this helps you.

http://www.cisco.com/warp/public/471/nm-xam_dialin.html

 

[BuckWeet]

Question for you though, how are you hooking a PRI/T1 up to the unit?

The modem module has all internal modems and still needs something to terminate a PRI or T1 into. Usually this is done with a VWIC module...


BuckWeet

 

[BuckWeet]

Oh wait, nevermind, I was thinking of a different modem #, forget what i just said..

BuckWeet