Hooligan71
Programmer
Hi,
Can anyone tell me what the pinouts for the programming lead
Many thanks
Can anyone tell me what the pinouts for the programming lead
Many thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
HiPath programming lead?
- Thread starter Hooligan71
- Start date
- Status
Silverblade
Technical User
If i'm not misstaken it is a null-modem cable. (one on one)
Hi hooligan71.
It uses a handle standard of routers Cisco and plus an adapter DB25 for RJ45. In case that it has in its HiPath 4000 a HubC plate, HiPath 4000 UV1.0/ UV2.0.. Atlantik LAN connectivity, uses only straight-through patch cord, both ends must be wired EIA568A.
Best Regards
Josué
It uses a handle standard of routers Cisco and plus an adapter DB25 for RJ45. In case that it has in its HiPath 4000 a HubC plate, HiPath 4000 UV1.0/ UV2.0.. Atlantik LAN connectivity, uses only straight-through patch cord, both ends must be wired EIA568A.
Best Regards
Josué
- Status
