Hipath 4000 TACSU

[swing25]

Hi Guys
I wanna change DGTPR AND ASSIGN ACwin-operator for destination of CO incomming.
would you help me?

 

[sbcsu]

You can set the Trunk to DGTPR=* and incoming calls will default to the Operator.

Alternatively you can CHA-TACSUGTPR=xxxx
COT/COP will need DITW set if you are Using DGTPR set to an extension

 

[swing25]

Thanks for your recommendation. I set DGTPR=* for all definded COP but doesn't act properly.
also I set DGTPR=XXXX for attendant private numebr ( on COP=10) and it is ok.
also on COP=10 I remove DITW FEATURE AND ADD NEW COP THEN SET DGTPR=* AGAIN ...
doesn't WORK

 

[sbcsu]

The ones below work for me, try them out with an unused COT/COP first

For NIN DIT (Direct Inward Trunk to extension) which rings to default answering point
ADD-COP:1,DTMF&RLSB&RLSA&SPTR&NTON&DTM1,TA,TA,,;
ADD-COT:1,RCL&XFER&CHRT&CEOC&CEBC&CPS6&RCLS&BSHT&CECO&ICZL&ICZO&CCTN&CTLS&NTON,,;
CHA-TACSUEN=X-X-X-X,COTNO=1,COPNO=1,COTX=1,DGTPR=*;


For DIT to Extension 1234
ADD-COP:2,DTMF&RLSB&RLSA&DITW&SPTR&NTON&DTM1,TA,TA,,;
ADD-COT:2,RCL&XFER&CHRT&CEOC&CEBC&CPS6&RCLS&BSHT&CECO&ICZL&ICZO&CTLS&NTON,,;
CHA-TACSUEN=X-X-X-X,COTNO=2,COPNO=2,COTX=2,DGTPR=1234;