HELP- pinout question

[nunzeo]

Does anyone know the pinout for a CO pack TN747b 8 port? i forget which pins on the 110 block are the ports?

thanks, nunzeo

 

[SteveS23]

use the blue.white white.blue pairs.

 

[4merAvaya]

Port 1 = White/Blue, Blue/White (Pins 01 & 26)
Port 2 = White/Brown, Brown/White (Pins 04 & 29)
Port 3 = Red/Orange, Orange/Red (Pins 07 & 32)
Port 4 = Red/Slate, Slate/Red (Pins 10 & 35)
Port 5 = Black/Green, Green/Black (Pins 13 & 38)
Port 6 = Yellow/Blue, Blue/Yellow (Pins 16 & 41)
Port 7 = Yellow/Brown, Brown/Yellow (Pins 19 & 44)
Port 8 = Violet/Orange, Orange/Violet (Pins 22 & 47)

Kevin

 

[nunzeo]

thanks steves23. i finally got a hold of someone and thats what they told me. now my lines are still not coming up. the are ground-start lines. i tested at the d-mark and they are fine. my trunk group is set to ground-start but when i add the lines in the trunk group they come up idle then go disconnected in STATUS. can you think of anything? nunzeo

 

[nunzeo]

thanks. you guys were a big help. the issue with this lines going in and out was a problem with SWB - it figures. thanks again. nunzeo