Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Help - module shows up in show ver but not in show int

Status
Not open for further replies.
madess

madess

MIS
Apr 17, 2003
36
US
I have just added a nm-1t3/e3 card to my 3745 and it shows up in show ver as 1 Subrate T3/E3 port but the module does not show up in show int?

what the heck?
 
Sort by date Sort by votes
This is what I had to do on my 2821 when we added our T1 VWIC cards - I couldn't see any serial interfaces either until I issued the following command:

"channel-group"

I think you have to issue this command from global config.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

jobsp90
  • Question
I have a issue in my office hospital network regarding using IPPBX software.
Replies
2
Views
248
DavetheChef
DavetheChef
Jared R
  • Locked
  • Question
Cisco UC320W Paging Help
Replies
0
Views
544
Jared R
Jared R
PThomp3344
  • Locked
  • Question
Trying to connect to Cisco Unified Controller web interface: UC520W-16U-4FXO-K9
Replies
1
Views
483
nt8d09
nt8d09
WinstonCH
  • Locked
  • Helpful tip
What is wrong with the diagram, there are people who will help to fix it? How do i do the configurat 1
Replies
1
Views
683
BIS
BIS
bfordz
  • Locked
  • Question
new help on setting up third party VoIP phones through Catalyst 2960x switch
Replies
0
Views
277
bfordz
bfordz

Part and Inventory Search

Sponsor

Back
Top