Hi I would like to know what is the command you can do to fine out what port a application would need so that you can open that port in your acl. I heard that you can run the application then go to the DOS Prompt and run a network command. how do you do this please.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
help finding out what port i need for application
- Thread starter loveroots
- Start date
- Status
Similar threads
- Locked
- Question