H. 323 upgrade file location? 4

[Rhinorhino]

After unzipping the H.323 upgrade files what location do I drop them in and do I need to do an Upgrade?

Thanks

 

[tsackl]

For IP Office 500v2 it is /system/primary (located on the SD-Card).
For Server Edition it is /Disk/system/primary.

Expand the zip archive and copy all files to the destination.
Do not forget to transfer the folder "signatures" as well.

 

[Rhinorhino]

Thanks the upgrade worked.

I now see the H.323 sets with the upgraded SW with I look at them I SS.

I was trying to get the J 179 to emulate the 9611 and I'm at this point in the Pic. Any suggestions?

 

[derfloh]

It didn't load the H323 firmware. You have to set the IPO as file server and change signaling to H323. It should.the reboot and load 96x1Hupgrade.txt followed by the 96x1 firmware.

But I never did this myself. Alternatively you can try to copy the 96x1Hupgrade.txt and save it as J100Supgrade.txt. But this will only work if the phone accepts the firmware even if the signaling is set to SIP.

 

[Rhinorhino]

Thanks I will make those changes.
In the meantime this is currently what the phone is displaying after a reboot

 

[derfloh]

Seems like it's asking for the file server address

 

[Rhinorhino]

This is my current setting in System/System:

 

[Rhinorhino]

The J179 s actually creating a user extension number

 

[Rhinorhino]

Also the J179s configuration shows an IP address for the phone and server and Mask have been automatically assign to the phone by the IPOs DHCP

 

[derfloh]

What is your question now?

 

[Rhinorhino]

It's just stuck on waiting for dhcp. Do I have the correct settings if it's looking for the file server address? Thank you

 

[derfloh]

You can configure all settings manual if the DHCP doesn't deliver the needed information.

IP address, subnet mask, gateway, HTTP server, call server, signaling

 

[Rhinorhino]

Yes I did that on the J179 config but it still is stuck.