I'm very familiar with programming a G700 from scratch, but I'm not very familiar with the G450 yet. When I do a 'show run' from a working G450, is this pretty much all there is in the config to get the G450 on the network and register to the server? If so, that's pretty simple. There's not much there...compared to a G700. I see the IP of the G450, the default gateway, the IP of the server it's registering to and some other stuff. If I were to configure a brand new G450 with only what I saw in the 'show run' of a working G450, is that really all it takes?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
G450 Config - Question
- Thread starter J1121
- Start date
The G450s and 430s are much simpler than the G700s.
All you need is a an MGP IP, default gateway and the MGC list.
Be sure to set the ports to 100/full with the follwoing commands.
set port negotiation 10/5 disable
set port duplex 10/5 full
set port speed 10/5 100MB
This is very important: DO A COPY RUN START
Unlike the G700, the G4xx gateways don't automatically save the config.
All you need is a an MGP IP, default gateway and the MGC list.
Be sure to set the ports to 100/full with the follwoing commands.
set port negotiation 10/5 disable
set port duplex 10/5 full
set port speed 10/5 100MB
This is very important: DO A COPY RUN START
Unlike the G700, the G4xx gateways don't automatically save the config.
- Thread starter
- #3
- Status
Similar threads
