telnet (or SSH, if you have not run "ip telnet") to the G350
"set sync interface primary v4" (if your MM710 T1/PRI is in slot 4)
"set sync source primary"
you can see if its working with:
"show sync timing"
example below is a G450, G350 and G700 are the same.
--------------------------------------------------------
Client-G450-001(super)# set sync interface primary v4
Done!
Client-G450-001(super)# set sync source primary
Done!
Client-G450-001(super)# show sync timing
SOURCE MM STATUS FAILURE
--------- ------------------- ----------------------- ---------------
Primary v4 Active None
Secondary Not Configured
Local v0 Standby None
Active Source: v4 Sync Source Switching: Enabled
Done!
Client-G450-001(super)#
mitch
AVAYA Certified Specialist