G250 to Core configuration

[RedTech443]

I am trying to configure my g250 as a media-gateway that registers to my core 6.3 environment. My g250 is at a remote site with some incomming copper lines, I will plug into the built in analog trunk ports, then use IP phones for the end devices. I may add another analog card in the future but for now this is all I have.

I am able to console into the g250 and I have factory reset it ot my liking, the sh run command does not give much info as it is factory now. I need some hole in my knowledge filled in.
From what I understand I need to.

1. Configure the g250 to point back at my core over ip address - I know something to do with console "MSG 10.40.0.10" or something like that (10.40.0.10) is my core ip.
2. configure the core cm to see the g250 and route 4 digit dialing coming form the remote site g250 correctly in my dialplan at core.
3. configure the g250 to route all local calls out its own copper trunk/pots lines

I basically want to have this as an extension of my core with all the benefits of the core over what I assume is going to be a h.323 trunk back to the core using one of the ports on the g250, then have all my voicemail and main site configurations features. I do not ned surviveability

Other questions.
on the g250 can I plug one of the 8 ETH POE ports into a switch and have all IP phones use that connection? Rather than have only 8 ip phones one plugged into each poe lan port?

Is there a good document somewhere for what I am trying to do that anyone has used, I have read many but I cannot find one tailored to my needs of what I am trying to do.
Thank you kindly for your knowledge and help.

 

[RedTech443]

So I am reading a document, and it says I need to do a set mgc list 10.40.0.10 (which is my core ip address) then reset the g250

So on g250 I do
clear mgc list
set mgc list 10.40.0.10
copy run start
reset

then that should link hae it looking to my core.?


Then on the cm6.3 side my core, I need to add a gatgeway under add gatgeway

Add media-gateway 6
type g250
name remote site
serial number: the number on the box
encrypt link y
region 2 (because this is my first remote site so a new regions of 2)
enable cf n
location 1 (not sure about this one)

it has no cards in it so I do not add any on page 2.

Does this sound about right or am I missing something?

 

[RedTech443]

Forgot to add something

After this I do all that, I need to plug the 250 into a switch at the remote site connected to my VPN back to the main campus, what port do I use on the g250, something so simple yet I cant find the info on that :/

Thanks for the help

 

[montyzummer]

You need to add the serial number into cm from the gateway , show system ,is the cmd in gateway

Then set your default gateway, the copy run start reset .up default gateway

Then #interface vlan 1#

Add ip and subnet

Exit

Show port and make sure your ports are in vlan 1

Copy run start and done.

APSS (SME)
ACSS (SME)
ACIS (UC)

 

[RedTech443]

Thank you all working and registering.