Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Flash VM

Status
Not open for further replies.

norstargirl

Vendor
Joined
Dec 21, 2001
Messages
223
Location
US
I am upgrading a flash vm from 2 ports to 4 but I can not get the vm to see the full 4 ports what am I missing?

M.Parnell
(norstargirl)
 
You should just have to plug in the expansion board and add a second digital station. If it doesn't see the additional ports I would say the expansion board is bad. Check the board for bent or broken pins. Also, connect your PC to the serial port of the Flash and watch the boot sequence. It might give you a clue as to what's going on. 9600, 8-N-1.

Brian Cox
 
Reboot, and pump 3 calls into Flash. I'll bet it will answer, unless bad 4-port expansion card.

Adversity is Opportunity
 
Or a bad extension. Have you plugged a phone into your second dn to make sure it comes up?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top