Fax press Server and Definity

[pghebreyesus]

I have a Definity PBX without Vectoring .. I recently purchased a castelle faxpress 2 port fax server and I am trying to set up a hauntgroup that will send the did 4 digit number to the faxpress for fax routing ... I was told definity sends few other characters before the 4 digit number but they will always be constant ..

Is this method I am exploring to use feasible?? Any suggestions or input will be greatly appreciated ..

Petros

 

[lopes1211]

No, you are not going to use a hunt group. You need to setup a trunk group and UDP table. You need to use a UDP table to point the range og DID's to a route pattern which will send the calls to the fax server trunk group.

-CL

 

[pghebreyesus]

Thank you for the response -- If I use your method will it shoot the 4 digit did to the fax server? Basically , All I want is a simple way of getting the destination number -- did -- to pass through in a language that the fax server will understand .. that way the fax server will route it to the destination ..

 

[lopes1211]

Yes, the tie trunk will pass the digits to the server.

-CL