External Call Foward

[nuevodia]

Hi:

I got a problem with external call forwarding. The set is programmed with NCOS 0 because here everyone use authorization codes to dial out. The set's class of service are: cfxa, unr.

I also program in the customer data block (LD 15) under RDR: OPT CFF.

The incomming lines are PRI lines and each one is programmed with NCOS 7 and CLS UNR. The Route is also NCOS 7.

IF I change the RDR OPT to CFO and the set to NCOS 7. the foward is completed.

Does someone know were is my problem??

 

[GHTROUT]

It looks to me like everything is doing what it should.

Maybe if you reword the description of the problem you are having.


~~~
[small]GHTROUT.com | Get the Input/Output Manuals | Tek-Tips FAQs | Recent Replies[/small]

 

[CSkabul]

try with XFA on the cls and pls make sure you have the XFA on the route

 

[nuevodia]

The problem is like this:

If set the forward to an external number and i call the extension from my cel it will not complete the forward. But if I dial the extension from another ext it will complete.

 

[CSkabul]

ya ya you have to enable trunk to trunk external forward.....
i have to look the manual...i will post later on what too do

 

[bigindian65]

ld 15
Net_Data

DITI YES
TRNX YES
EXTT YES
FTOP FRES

Mato' Was'aka

 

[GHTROUT]

BigI: If FTOP was previously enabled and working as a restriction method, you just turned it off for all stations and voice mail ports.

FTOP applies to trunk to trunk transfers/conference at the station level. I do not think it applies to CFW at all.

nuevodia - you wrote "IF I change the RDR OPT to CFO and the set to NCOS 7. the foward is completed. "

So, do that? You posted that it works.


~~~
[small]GHTROUT.com | Get the Input/Output Manuals | Tek-Tips FAQs | Recent Replies[/small]

 

[nuevodia]

nuevodia - you wrote "IF I change the RDR OPT to CFO and the set to NCOS 7. the foward is completed. "

So, do that? You posted that it works.


I could do that but the authorization code will not work

In my system the Net data have


DITI YES
TRNX YES
EXTT YES
FTOP FTLY

 

[nuevodia]

In the RDR_Data in OPT, for what is CFO for??

 

[mrmhar]

the same problem still i am facing search the thread forward to external number

 

[yyrkroon]

change the ncos on the incomming trunks to be 1 higher than the MFRL of the intented RLI.

Set your OPT in RDR to CFO, may need to do the same with OPT for NET.