Error configuring a CO Trunk: Object type and port type inconsistent.

[Minser]

I need to configure a "mobile access" (I don't know what is correct name in english) through analog line to reduce costs when the company calls to cellular phones.

I've inserted a TN465C CO-TRK board and I've added a trunk with "Group Type: CO". When I want to assign group members using ports of my CO-TRK board this message appears: "01A1101" Object type and port type inconsistent

My board is in 01A11, I've used Busy/Release command, I've tested board and all results are PASS. I don't know what changes/tests can perform. Someone can help me?

Sorry for my english, I hope all of you can understand my explanation. Thanks.

 

[Lostpbx]

If I'm understanding you correctly you might not want a CO trk board. Do you need a Analog extension out of the phone system to make calls to cell phones or do you need a Analog line from the PSTN to make calls to cell phones?

 

[Minser]

Hi Lostpbx,

I need a Analog Line from PSTN to make calls to cell phones. This Analog Line is connected to a device with a analog line Input.

This device contains a SIM card, exactly the same you can put in a cell phone. This device (I previously called "mobile access") converts into cell phone calls every call you send through analog line.

To configure a Analog line you need to put it in a Trunk-group and you need a CO-Trunk board. Is it correct? Can I do it in other way?

Thx,