Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Emergency Transfer Panel power supply
- Thread starter nord860
- Start date
I use the Avaya 1115B1 Power supplies for IP Phones just plug into same outlet or source as S8300 and wire output
from power supply / pins 7 / 8 ( brown pair ) to the
Emergency Transfer units power input I have done it for
S8500 sites as well unlike the older PBX which supplies
it off the Aux card.
make an Rj45 clip as you normally would and connect to
"output" from Ext Power Supply and cut down on a punch down block then crosswire the brn pair -48 /grd to your Amp tail for the power transfer unit.
Cheers
ayavauser
from power supply / pins 7 / 8 ( brown pair ) to the
Emergency Transfer units power input I have done it for
S8500 sites as well unlike the older PBX which supplies
it off the Aux card.
make an Rj45 clip as you normally would and connect to
"output" from Ext Power Supply and cut down on a punch down block then crosswire the brn pair -48 /grd to your Amp tail for the power transfer unit.
Cheers
ayavauser
- Status
Similar threads
- Locked
- Question
- Locked
- Question