I changed my processor(from an athlon 1.2 to an unlocked 1.0, this involved removing and reseating my ELSA GLADIAC GeForce 2 MX (AGP) and removing and reseating the memory (2 x 256mb pc133 SDR SDRAM - from Crucial). I also had to take out the PSU (I only removed the ATX Power Suppy Cables - THE PSU is 300W). THe machine powered up (power went to the motherboard and I could hear the fan and all motherboard and front panel lights lit and think i can hear the HDDs starting) but did not boot and no signal to the monitor. Then put old athlon back in and still didn't boot. I have tested the memory and its fine, have tested spare memory in the machine to no avail. Any Suggestions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
ECS K7SEM Not Booting
- Thread starter iono
- Start date
Guest_imported
New member
- Jan 1, 1970
- 0
I noticed this problem with some Athlons and certain MBs. If you hit the reset switch after the initial power on, it will sync with the monitor.
- Thread starter
- #4
- Status
Similar threads
- Locked
- Question
- Locked
- Question