Echo Cancellation analog lines ms option missing?

[qtelcom]

Have a IP500v2 system on GA R9, and looking at echo cancellation for analog lines, my only options are On/Off and I can't select the milliseconds. Where did this go? This is combo card with the ATMv2 (COMBO6210/ATM4 V2)


Doc's state this, yet my only option is On/Off in Manager.
Echo Cancellation: Default = 16ms.
Allows settings of Off, 8, 16, 32, 64 and 128 milliseconds. The echo cancellation should only be adjusted as high as required to remove echo problems. Setting it to a higher value than necessary can cause other distortions. Not used with external expansion module trunks.

 

[amriddle01]

Yes, that seems to be the only options with the V2 cards, they just haven't bothered updating the docs...again

 

[qtelcom]

usually V2 means something better, but I guess they dumbed this option down... grrrrr...

 

[madwok]

With 8.1.67 , the AMT2 would ALWAYS drop the line when you dial up via the modem and make a change to the system configuration . ATM1 worked fine for this remote maintenance function :-(((

 

[madwok]

With 8.1.67 , the AMT2 would ALWAYS drop the line when you dial up via the modem and make a change to the system configuration . ATM1 worked fine for this remote maintenance function :-(((