technicholas
IS-IT--Management
We have a T1 E & M Tie circuit from CenturyLink is there any way we can get our carrier to pass us caller ID incoming?
Nicholas
Nicholas
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
E&M Tie CALLER ID
- Thread starter technicholas
- Start date
- Status
- Thread starter
- #3
technicholas
IS-IT--Management
We don't guarantee caller ID on a T1
amriddle01
Programmer
Then that's your answer, nothing you can do your side to effect their service 
There is no standards-based method to deliver caller ID on an E&M Tie line. There is a provision for *DNIS*ANI* (or maybe it's *ANI*DNIS* - it's been many years since I've last used this), but I don't think IPO will support it. Is it CenturyLink's CO at the other end of the Tie line delivering regular calls? If so, easiest is to convert to PRI.
- Thread starter
- #6
technicholas
IS-IT--Management
They won't give us a PRI old Ericson equipment at CenturyLink
StubbedmytoeonIPO
Programmer
The last E&M TIE Line in IPO I did was on a 406 7 years ago and IPO did not support Caller ID at that time. I doubt it has changed since then but can't be sure.
- Status
Similar threads