GrandmasterOPI
IS-IT--Management
Anyone setup analogue networking using alog lines
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
duhhhhh
- Thread starter GrandmasterOPI
- Start date
- Status
This is not supported, as the IPO, does not have a ALOG Modem router installed only stight IP, frame, xDSL or ISDN routing is supported.
With Version 2 you can however gain access remotly to a IPO via the Build in V.32 modem, which you can confiure on the SOE or 4 Port Alog trunk card. However thsi is only 9600bps, but is enough to gain access to the IPO configuration via manager. Its just not good for true V.90 remote access.
Hope this helps
With Version 2 you can however gain access remotly to a IPO via the Build in V.32 modem, which you can confiure on the SOE or 4 Port Alog trunk card. However thsi is only 9600bps, but is enough to gain access to the IPO configuration via manager. Its just not good for true V.90 remote access.
Hope this helps
- Status