NorstarOption
Technical User
I have 5 sets that I would like stay enabled even the sets are unplugged overnight. I believe there is a CLS I can enable to make this happen. Does anyone know which CLS is this?
Thanks.
Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Don't Disable Sets 1
- Thread starter NorstarOption
- Start date
- Status
-
1
- #2
CLS FLXA
~~~
[small]GHTROUT.com | Get the Input/Output Manuals | Tek-Tips FAQs | Recent Replies[/small]
~~~
[small]GHTROUT.com | Get the Input/Output Manuals | Tek-Tips FAQs | Recent Replies[/small]
- Thread starter
- #3
NorstarOption
Technical User
What's all these warnings for? Do I have to program anything else beside changing the CLS to FLXA on the TN?
By entering FLXA, you may configure dynamic voice/data
TNs by assigning VCE to the upper TN (unit 16-31) and
DTA to the lower TN (unit 0-15). You also have the option
of designating a SCR key as DTM (data mode).
Warning: If connecting the Aries set only to the TCM loop,
this option should not be specified. External equipment
which can use this capability should be connected.
Warning: When changing from CLS DTA to CLS VCE,
CLS WTA should also be assigned to avoid conflict with
CLS CPTA. CLS CPTA is the default for VCE TNs.
By entering FLXA, you may configure dynamic voice/data
TNs by assigning VCE to the upper TN (unit 16-31) and
DTA to the lower TN (unit 0-15). You also have the option
of designating a SCR key as DTM (data mode).
Warning: If connecting the Aries set only to the TCM loop,
this option should not be specified. External equipment
which can use this capability should be connected.
Warning: When changing from CLS DTA to CLS VCE,
CLS WTA should also be assigned to avoid conflict with
CLS CPTA. CLS CPTA is the default for VCE TNs.
No, nothing else. It is not a documented method - it just works. I do it on lots of TNs.
Whatever generated those messages thinks you must be configuring a data TN (unit 16 and up) but you know you aren't
If you do a forum search on "FLXA" you'll see it has been posted as an accepted method for years.
~~~
[small]GHTROUT.com | Get the Input/Output Manuals | Tek-Tips FAQs | Recent Replies[/small]
Whatever generated those messages thinks you must be configuring a data TN (unit 16 and up) but you know you aren't
If you do a forum search on "FLXA" you'll see it has been posted as an accepted method for years.
~~~
[small]GHTROUT.com | Get the Input/Output Manuals | Tek-Tips FAQs | Recent Replies[/small]
- Status
Similar threads
- Locked
- Question
- Locked
- Question
