Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Display Dies 2/3 of way through XP Install at "Installing Drivers"
- Thread starter ChillLead
- Start date
- Status
- Thread starter
- #3
ati agp all in wonder 9800 pro is the graphics card.
resetting the apeture (in bios) to 128 fixed the problem, but now the monitor does not show the edges of the desktop so that I can see only the top edge of the start button. Also, res is set at lowest (4xx X 6xx) and increasing makes icons bigger, not smaller???
having trouble installing drivers too. drivers that came with the board are so old as to be out of date. drivers downloaded from ati install ok, but do not resolve the issue.
resetting the apeture (in bios) to 128 fixed the problem, but now the monitor does not show the edges of the desktop so that I can see only the top edge of the start button. Also, res is set at lowest (4xx X 6xx) and increasing makes icons bigger, not smaller???
having trouble installing drivers too. drivers that came with the board are so old as to be out of date. drivers downloaded from ati install ok, but do not resolve the issue.
I know that some ATI cards did have a problem, but I think that was in Windows 2000. I had one swapped out by ATI a long time ago to resolve the issue. It sounds like the drivers are not that compatible with XP. What speed is your AGP port set to in the BIOS? Shouldn't make any odds, but if you are able reduce the AGP ports speed. It could be that the card is having a problem if the ports speed is set above it's rating.
- Thread starter
- #5
I think the card is 5X if memory serves. bios only has 4X & 8X settings, and i have it set to 4x.
Now I'm having another problem: I disabled the monitor driver and monitor loses signal at boot up. I see windows logo, then "no signal."
bios works ok, safe mode, here i come....
Now I'm having another problem: I disabled the monitor driver and monitor loses signal at boot up. I see windows logo, then "no signal."
bios works ok, safe mode, here i come....
Yes, going into safe mode you should be able to get the monitor working again. Why did you disable the driver?
There never was a 5x speed for AGP as far as I know. From what I have found this card is 4x. Have you tried setting the BIOS to 8x? It should be backwards compatible. Is this card the Pro version with the TV out & remote? If so it looks like it is about 4 years old & shouldn't really have a problem with Windows XP. Also, another thing I noticed was that it should have a seperate power lead to the card itself. Does it? & is this supplying the correct voltage?
There never was a 5x speed for AGP as far as I know. From what I have found this card is 4x. Have you tried setting the BIOS to 8x? It should be backwards compatible. Is this card the Pro version with the TV out & remote? If so it looks like it is about 4 years old & shouldn't really have a problem with Windows XP. Also, another thing I noticed was that it should have a seperate power lead to the card itself. Does it? & is this supplying the correct voltage?
- Thread starter
- #7
- Status
Similar threads
- Locked
- Question
