digital phone line with analog output

[ezekiel97]

Hey guys, looking for some help here. Right now I have a couple phone lines that have to be analog to go through a digital voice logger(DVL) to record calls for playback. The DVL only accepts analog and only outputs in analog. Our current setup has 3 type 500 analogs going from the node to the DVL and then into a really old Northstar E-Key system. The Northstar is starting to fail and I'm tring to go all Nortel for the system. I was told that there was a digital handset where I would go from the node to the handset and the handset had an analog out that we could push to the DVL that would record both sides of the phone call. I haven't found this phone and have no clue on where to look this up at. My telephony skills are very weak since the most telephony I do is just move users phones around.

 

[Firebird Scrambler]

Some years ago, there were Nortel digital phones that had an adapter to add in an analogue port and I seem to recall that it was configured via one of the data ports in the range 16 to 31 that existed on the digital card.

I've found this old record below.

Analogue terminal adapters (ATA) on Taurus Telsets
Only supported on M3902, M3903, M3904 & M3905

Unsupported features:-
Message Waiting, Switchhook Flash, Transfer, Conference & Class type services

Only supported on M3902, M3903, M3904 & M3905
Requires
1. Accessary Connection Module
2. Analogue Terminal adapter
3. Inline Mains Transformer

Configure in LD 11
Digital ports 0 - 15
Analogue ports 16 - 31
For Analogue port configure Digital port plus 16
ie. port 0 = digital associated analogue port = 16
port 1 = digital associated analogue port = 17
etc
port 15 = digital associated analogue port = 31


Firebird Scrambler
Nortel Meridian 1 / Succession and BCM / Norstar Programmer in the UK
Advance knowledge on BCM support

http://www.linkedin.com/in/davidbromley