Hello all,
I have a G3 Definity running V9 and cannot get the DID Trunk to signal the stations.
On a new turn up we installed a TN767E
We installed a DID access trunk configured DS-1,Robbed Bit with CAS MF signaling and Wink Start.
The circuit is clean, no slips or errors.
The incoming signaling is 10 digit MF (kp npa nxx xxxx st)
This has been verified with a test set decoding.
We have the Trunk set to absorb 5 digits expecting 10.
The station attempting to be signaled is 5 digits as set in the dial plan.
Calling the station locally from another station is fine.
The switch never routes to the station.
If we change the drop treatment to silence we get silence when calling the DID.
When we select intercept with unanswered DID feature pointing to an announcement we get reorder tone from the switch.
It acts like it is not decoding the MF.
Any ideas?
I have a G3 Definity running V9 and cannot get the DID Trunk to signal the stations.
On a new turn up we installed a TN767E
We installed a DID access trunk configured DS-1,Robbed Bit with CAS MF signaling and Wink Start.
The circuit is clean, no slips or errors.
The incoming signaling is 10 digit MF (kp npa nxx xxxx st)
This has been verified with a test set decoding.
We have the Trunk set to absorb 5 digits expecting 10.
The station attempting to be signaled is 5 digits as set in the dial plan.
Calling the station locally from another station is fine.
The switch never routes to the station.
If we change the drop treatment to silence we get silence when calling the DID.
When we select intercept with unanswered DID feature pointing to an announcement we get reorder tone from the switch.
It acts like it is not decoding the MF.
Any ideas?