DID help 1

[fmielbye]

Hi, I recently added a block of 40 DID's to a PRI terminating into an Option11. The new DID's have a prefix of xxx-788-xxxx. The exsisting DID's are all xxx-585-xxxx. I programmed a few phones using the new DID's and when I place a call to them with my cell, xxx-788-xxxx it reaches the phone just fine. When I call out to my cell from the new DID my calling line ID on my cell displays the 585 prefix instead of the correct 788 prefix. Do I need to program the new prefix in the switch and if so where should it go? Any help would be greatly appreciated.

Thanks, Fred

 

[johnpoole]

ld 21
prt
clid
0

you should see a clid enrty 0. go to 15 and add table 1, chg net then on the sets with the new did

key 0 scr 4444 1

that will show clid table 1

john poole
bellsouth business
columbia,sc

 

[fmielbye]

Thanks John. I'm begining to see the light. Once in 15 how do I add table 1.

Chg
Net


Thanks

 

[fmielbye]

Figured it out. Thanks once again for your help.