DID digits over T-1

[ToddGivens]

Need Help. We are installing a T-1 between our fax server and G3. We would like to have a block of DID numbers that come in on our local PRI go across the T-1 into our fax server so everyone can have their own fax number. How can we get the DID number that comes in on the PRI retransmitted on a T-1 channel?
Thanks so much!!

 

[GoKings]

You can setup the fax did's to cover just like they would to a voice mail, but use remote coverage to go across the T1. I don't what your fax server wants to see in order to identify which fax did the call came from, so that will be a separate challenge.

 

[hauchinango]

Through UDP and AAR. Change UDP on your new extensions range of the fax DID'd. Set up AAR with a new route pattern to the T-1 connecting the fax server. Remember to delete the proper amount of digits (the digits of your UDP code) in the route pattern. Should work fine.

 

[ToddGivens]

Thanks for your reply. Will this use up 100 software ports? I only have a select few and would like to use them sparingly.

Thanks again,
Todd

 

[ToddGivens]

Robertmaj

We'll give that a try. So the DID digits will be repeated across the T-1 to the fax server? Appreciate your reply.

Todd

 

[hauchinango]

Yes, Lets say for instance your DID's for the fax server are 1000 to 1999. Your UDP would look like this:

Ext Code: 1xxx Type: UDPCode 221

Your AAR:

Dialed Total Route Call Node ANI
String Min Max Pattern Type Num
221 7 7 3 aar 1 n

Route Pattern 3 would use the Trunk Group of the T1 to Fax Server, Deleting 3 digits (the 221). So the DID's, 1000 to 1999, will appear to the fax server as such. Hope this helps.


As far as I know,

 

[hauchinango]

PS: Should not count against your station ports.