did a reset on an 1841 1

[karmic]

Had an 1841 router that was in a real mess so did a factory reset on it. Couldn't reconnect with the typical 10.10.10.1 so I tapped in with the console. It was sitting at rommon 1>

Type boot and up it came. Configured the router and rebooted it again... rommon 1 again.

Type boot, up it comes.

How do I get this thing to boot my config automatically?

~ K.I.S.S - Don't make it any more complex than it has to be ~

 

[brianinms]

Check the configuration register. When you do a "show ver" it should be set to 0x2102, if it is set to anything else you need to change it .....

router#config t
router(config)#config-register 0x2102

Then wr mem and reboot

 

[karmic]

That worked, thanks

~ K.I.S.S - Don't make it any more complex than it has to be ~