Determining System Version for PRI or Plain T1

[jchriscoe]

I have a customer that need to connect a PRI to a Norstar ICS system version 30m1f05 NAT.

Does this version allow PRI?

How can I decifer the system version?

If it doesn't allow PRI will it work with a plain T1?

Are there key codes required for any of the above to work?

Any help on this would be greatly appreciated.

Jeff

 

[senk1s]

assuming the 1 is an l - mics 4.0
first rel of PRI ...(read as 'buggy' - suggest an upgrade)

PRI requires keycode + DTI + services card
T1 will work with DTI + services card

 

[jchriscoe]

Thanks for the reply.

I believe the 1 should have been a I.

What release level would you recommend for PRI?



jchriscoe
North Carolina

 

[HUCHIMAMA]

I always use 6.1 for PRI's. I haven't had any issues with 6.1

kgrant

 

[hawks]

Make sure that it is the last RLS of 6.1 the ealier releases did have issues.

 

[please123]

Or go to 7.0 since it has no issues, and your not looking to make sure it's the later 6.1 release.

 

[jchriscoe]

Thanks to all who have replied. Great information.

I know Norstar equipment can be bought from non-authorized Nortel company, can upgrades be purchased from these types of companies as well?

jchriscoe
North Carolina

 

[senk1s]

just make sure they can and will support you/the products they sell - ALL the way

 

[hawks]

Just make sure that you complete any upgrade before you get any new key codes. The reason I say this is because if you have any problems upgrading the system & have to go back to the lower software there is a good chance that your system ID will change therefore making any key codes that you have no good.

 

[jchriscoe]

Thanks to all who responded!

jchriscoe
North Carolina