Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Determining switch duplex setting from DOS
- Thread starter bradje
- Start date
the only way *i* know is to telnet to the thing, and look at the port config. if you could figure out a way to pull up stats for that interface, and look at the collisions stat, if it was zero, that would strongly indicate full duplex. maybe somebody else can chime in ...
- Status
Similar threads
- Locked
- Question