DEFINITY, SMDR, whats needed? 1

[ryan47]

G3 version 7,,, what will i need to make this happen,, do i use the DCE to connect,,, do i need a card, computer software?? Im familiar with Nortel with a RAD,, but not sure of the avenue to take for SMDR and Definity,, pls. help...

 

[prflash]

I just went through this last week. I have a G3R V4. No DCE output port on the back. If you have a DCE output port then connect right to the back with the device. If you do not have the port then you will have tp programm a data module and connect it via some sort of Data Mod device.
You can go to thread 690-1169706 for further explanation
Good Luck

 

[wellco]

Best way is the DCE port using 355af to your com port on computer running software to take the rawcall data Microcall is the best but thats me. run a cable inbetween switch 355af to comp. 355am or whatever then you'll need to take that down to a 9 pin for com1. tryed using a data mod on same system g3v4 tall boy could'nt for the life of me get it up and running always junk over a digital station data mod. 355's are hard to come by but they always do the trick for CAS. with only a cat3 or cat 5 with rj45end's straight. had to slow baud rate to 300 works like a champ. ch sys fe_ make it eia all u need, can also monitor incomming traffic if needed and you have pri lines.