DCH messages flying up the screen 1

[M1north]

Release 23.55 Option 61C

T1 programmed using Loop card/720 card/MSDL

I run a sleftest on the loop and it fails.

Then I get these messages runing the screen for 5min

DCH: 58 DISABLE INDICATION TIME: 16:58:46
REASON - **(00000086 )

DCH: 58 DISABLE INDICATION TIME: 16:58:46
REASON - **(00000086 )

DCH: 58 DISABLE INDICATION TIME: 16:58:46
REASON - **(00000086 )

Then it stops:

DCH: 50 EST CONFIRM TIME: 17:03:26 20/06/2009

DCH: 18 EST CONFIRM TIME: 17:03:26 20/06/2009

DCH: 58 RLS CTS DOWN TIME: 17:03:32 20/06/2009

AML: 15 AUDIT START:FRWR SL1 STATE NOT EQUAL
AML: 15 AUDIT GOOD DSBL
AMLM033 15

PRI006 27

While the messages were going up the screen I did the following:

Pulled the 720 card
dis and pulled the loop card
dis and pulled the msdl card

All of the above didnt stop these messages:

Any idea of the end result here?

Thx

 

[M1north]

Then I get this:

IOD322 Int detected: unconfig'd IO device; grp 0 @ vaddr 0x3090
device has been H/W disabled

 

[M1north]

OK, I think the 720 card was bad and even though I removed it the PBX was still trying to send the disable command to the MSDL but it couldnt get through the 720 card.

AM I totally off on this?

 

[johnpoole]

did you download the msdl? it tried to come up but saw a software mismatch.. usually interface type.. the 720 does not look bad from those dch's..

ld 96 dis msdl x all
enk msdl x fdl

writes the software to the card, without that step the msdl never loads

unconfig'd IO device; grp 0 @ vaddr 0x3090,

are you sure your io switch settings are correct.. io switch setting would block a download

john poole
bellsouth business
columbia,sc

 

[M1north]

This is a late replay but thanks to John that fixed the problem. The system reloaded the day before and the MSDL card was never FDL.

Thx

 

[SpelingChampeon]

M1north, you were probably seeing all those messages after you pulled the card because the buffer was still processing those errors. I've seen the buffer get so full, the switch INI's because it cant handle them all.

Glad to see you got things squared away.