Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cutover Command
- Thread starter PhoneGuyy
- Start date
It is an INI of the switch to force the processor to go to CPU 1 in your case. An INI takes about 1 minute to complete. If you upgraded Core 1, it could take several minutes to complete because of the firmware upgrade of your system. i.e. t1 cards, fiji cards, controllers, msdls.
What it does is disable Core 0 and INIs Core 1 if you were upgrading Core 1. That means Core 0 was on line while you were upgrading Core 1. The T1 PRI dchs could take about 2 minutes or so to establish. You will have dial tone but can not call out if your only outdial is via T1 PRI.
What it does is disable Core 0 and INIs Core 1 if you were upgrading Core 1. That means Core 0 was on line while you were upgrading Core 1. The T1 PRI dchs could take about 2 minutes or so to establish. You will have dial tone but can not call out if your only outdial is via T1 PRI.
- Status
Similar threads
- Locked
- Question
- Locked
- Question