CS1000M SG/CP PIV Rls 6.0 Stuck in split mode. 5

[jake82nd]

when I type JOIN the switch comes back with "Cannot join, the redundant partition is not synced." I have tried to ini. the inactive core as well as reboot the inactive core. They both look ok and it comes back up in split mode. Any Ideas?
Thanks.

 

[Firebird Scrambler]

No I didn't have the guts to try that one. Lol!. Actually, I found that solution that another engineer had done.

All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[KCFLHRC]

I just had one of these on an 81 last night do the same thing. CPU's were in sync but hard disks were not. Unplugged the HSP and plugged back in and started syncing. After syncing was one you could not split the cores. Sysloaded the inactive side and it did a sync with the active side put still could not split. Unplugged the HSP, INI'ed the active side and sysloaded the inactive. Then plugged in the HSP and let them sync. Then I could split them and join them. It was a little fussy but I kicked it's butt.