CS1000M PRI to Polycomm RMX

[guycable2]

Hi

Anyone have experience connecting a CS1000M to a Polycomm RMX video bridge?

I have it connected using a NI2 COT route and it works inbound with no issues but outbound the call just hangs. I see the 91-npa-nxx-xxxx coming through on the dchannel to the RMX but never see it hit our LD trunk group D-channels.

It appears the RMX doesn't support QSIG so I'm unsure what other protocols to try. Polycom recommended NI2.

Thanks

 

[atascoman]

Check the NCOS of the trunks on the TIE between the Polycom and your CS1000. If the NCOS of the trunks is 0 and 0 is not allowed to dial LD that would cause an issue. I have seen that a lot.

Also check your TGAR and TARG settings on the routes and make sure the Polycom trunks are not having a conflict there. If the TGAR on the TIE trunks matches the TARG on the LD route then they will not be able to dial out.

 

[sporty2]

Are your trunks set as VOD? I have had issues setting up a call when they were vce in the RDB.

sporty2

 

[guycable2]

checked ncos targ/tgar and have the RDB set to 3VCE no luck. I'm beginning to think it's time to try something other than NI2 but I'm not sure which protocol to use.

 

[NortelGuy1979]

Can you post the RDB, DCH, and a T1 TN of your NI2 to the RMX, and then the same for your external trunks? Also, your NET_DATA block.

Then, a DCH trace of both the RMX and the external DCH for the same call (RDX --> PBX --> PSTN) would be helpful.

Matthew - Technical Support Engineer

http://www.linkedin.com/in/matty79

 

[Nortelanyone]

Can anyone provide the configuration of a CS1000 PRI tie trunk to a Polycom RMX video bridge but to be used as voice only? D channel is established but when we dial the DID the call hits the RMX entry queue and then disconnects. On the phone we just hear ringing. RMX configured as DMS100 switch type and network side clock source.

Thanks in advance!

 

[guycable2]

This is what I ended up using to get it to work.

REQ: prt
TYPE: rdb
CUST 0
ROUT 40

TYPE RDB
CUST 00
ROUT 40
DES POLYCOM_BRIDGE
TKTP TIE
M911P NO
ESN NO
CNVT NO
SAT NO
IDEF NET
RCLS INT
VTRK NO
NODE
DTRK YES
BRIP NO
DGTP PRI
ISDN YES
MODE PRA
IFC D250
SBN NO
PNI 00001
NCNA YES
NCRD NO
CHTY BCH
CTYP UKWN
INAC NO
ISAR NO
CPUB OFF
DAPC NO
BCOT 0
MBXR NO
DSEL 3VCE
PTYP PRI
AUTO NO
DNIS NO
DCDR NO
ICOG IAO
SRCH RRB
TRMB YES
STEP
ACOD 8640
TCPP NO
PII NO
AUXP NO
TARG 01
CLEN 1
BILN NO
OABS
INST
IDC NO
DCNO 0 *
NDNO 0
DEXT NO
ANTK
SIGO STD
ICIS YES
TIMR ICF 512
OGF 512
EOD 13952
NRD 10112
DDL 70
ODT 4096
RGV 640


PAGE 002

GRD 896
SFB 3
NBS 2048
NBL 4096

IENB 5
TFD 0
VSS 0
VGD 6
DRNG NO
CDR NO
VRAT NO
MUS NO
RACD NO
EQAR NO
FRL 0 0
FRL 1 0
FRL 2 0
FRL 3 0
FRL 4 0
FRL 5 0
FRL 6 0
FRL 7 0
OHQ NO
OHQT 00
CBQ NO
AUTH NO
TDET NO
TTBL 0
ATAN NO
PLEV 2
ALRM NO
ART 0
SGRP 0
ARDN NO
AACR NO

ADAN DCH 34
CTYP MSDL
GRP 1
DNUM 14
PORT 0
DES Polycom_Bridge
USR PRI
DCHL 34
OTBF 32
PARM RS422 DTE
DRAT 64KC
CLOK EXT
IFC D250
SIDE USR
CNEG 1
RLS ID **
RCAP
MBGA NO
OVLR NO
OVLS NO
T200 3
T203 10
N200 3
N201 260
K 7