CP 150 Mini Won't Boot Up

[firefoxfire]

It has been going offline for the last week or so. I would power cycle it and then it would work ok for several day. Now when I cycle it all lines 1-4 stay lit but then 10/100 and the three other green indicators below flash for about 2 seconds then do not start going through there usual cycle. I have a new power supply on it because when I first took on this client I found the CP had been offline for several years already.

 

[Firebird Scrambler]

I had a problem like yours and it was still the power unit. You do need to have the same type of transformer adapter.

All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[firefoxfire]

I used another power supply, this was from another CP that is working ok on another CP. I took out the software and installed it into another CP and it worked ok.

 

[hawks]

Check your power supply, if it's a 9V then it could have damaged the cabinet.

 

[curlycord]

Did you try the working software on the broken CP




=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[firefoxfire]

Yes, same thing. The strange thing about the SW from the CP 150 Mini is that I was able to boot it up and even get into F983 but F981 keeps saying EXIT. I also noticed that the 32 MB SW will only show 10 MB on the CP 100. I can only set up a INFO MB.

I attached a SERIAL cable and tried to log into it via the PC web browser and al I keep seeing are the same 4 green lights.