Connecting 2 406v2 non-scn

[haironfire]

Site A - 406v2 3.2.61 vcm vmpro extn's 3000 range
line 50 with ip address of site B's ipoffice

Site B - 406v2 3.2.61 vcm vmpro extn's 4000 range
line 50 with ip address of site A's IP Office, outgoing group 50
SC 3xxx dial 3xxx line 50

Can successfully ping each ip office from the vmpro pc at the other site

When i dial 3xxx from site B in call status i see the number being dialed on line 50 but call drops and receive "busy signal". On a network with Cisco routers programmed by a 3rd party. Does this sound like a routing issue in the Cisco or something i overlooked in the ipoffice?

 

[ThePhoneMn]

open system monitor on site B and make a call from site A. If Sys Mon shows activity on line 50 then it is most likely an IPOffice configuration issue.

 

[amriddle01]

Try changing the Dial section to . instead of 3XXX If no joy it does sound like a routing issue,H323 fixups need removing in the Cisco's I'll bet.

ACS - IP Office Implement