Connect an ISDN-Card to G3-V6

[mfutschek]

Hi; i tried to connect an isdn-pcmcia-card(eicon-diva) to a tn556d-module.
So,the wiremap is ok,a L1-link and D-channel is up. AND HERE IS THE RPOBLEM: when i'm trying to dial each number with each software,the B-channel is up for a few milliseconds and then down.Sytem is G3V6.

I hope,i've configured the TN556 correctly:

display station 4551 Page 1 of 4 SPE B
STATION

Extension: 4551 BCC: 0
Type: WCBRI TN: 1
Port: 01A1101 Coverage Path 1: COR: 1
Name: test-isdn Coverage Path 2: COS: 1
Hunt-to Station:

STATION OPTIONS
Data Module? y






BRI OPTIONS
XID? n Fixed TEI? n 1-Step Clearing? n
Country Protocol: etsi Endpt Init? n

display station 4551 Page 2 of 4 SPE B
STATION
FEATURE OPTIONS


CDR Privacy? n
Data Restriction? n
Per Button Ring Control? n



H.320 Conversion? n
Per Station CPN - Send Calling Number?

Audible Message Waiting? n

display station 4551 Page 4 of 4 SPE B
STATION

DATA MODULE

Data Extension: 4552 Name: msn-test
COS: 1
COR: 1 Multimedia? n
TN: 1
ABBREVIATED DIALING
List1:

SPECIAL DIALING OPTION:



CIRCUIT SWITCHED DATA ATTRIBUTES
Default Duplex: full Default Mode: async Default Speed: 1200

DATA MODULE CAPABILITIES
Default ITC: restricted Default Data Application: M2_A


Any ideas to resolve??

 

[lopes1211]

Where are you dialing to? If outside of the PBX, do you have PRI out to the public network? Does your PRI provider support 64K SDS?

-CL

 

[mfutschek]

hi,lopes1211;
i'm dialing outside of the pbx and i have an ISDN-PRI out.
And i think ,my provider supports 64k SDS,because i have tried this PRI with an E1-PRI-Card from a Cisco-Router,so that was succesfull.

 

[lopes1211]

check the route pattern you are using and make sure the btc/itc is set for "both" instead of "rest".

-CL

 

[mfutschek]

hi,lopes1211;
it's now fully working;i have corrected this entry in the route-pattern.

Many Thanks and greeting from Vienna