We recently moved our network to a new building and our new provider furnished us with an Adtran 608 router (no customer access). I would like to replace this unit with the 2620 from our old network so we can administer the router locally.
Can someone provide step-by-step instructions for the setup of the 2620. It has one FastEthernet interface and one Serial interface. Our office has a T-1 with 64 public IP addresses (Subnet 255.255.255.192). The loopback device is currently connected to the Adtran router and our network is up and running.
I have the WAN IP address information and our IP address information and know how to get to the initial setup screen of the 2620 using Hyperterminal. Our provider gave us the green light on replacing the router.
Can some give me step-by-step instructions from here.....
------------------------------
rommon 1> confreg 0x2142
rommon 2> reset
would you like to enter the initial configuration dialog? YES
---------------------------------
Any help would be appreciated!
Thanks,
Greg.
Can someone provide step-by-step instructions for the setup of the 2620. It has one FastEthernet interface and one Serial interface. Our office has a T-1 with 64 public IP addresses (Subnet 255.255.255.192). The loopback device is currently connected to the Adtran router and our network is up and running.
I have the WAN IP address information and our IP address information and know how to get to the initial setup screen of the 2620 using Hyperterminal. Our provider gave us the green light on replacing the router.
Can some give me step-by-step instructions from here.....
------------------------------
rommon 1> confreg 0x2142
rommon 2> reset
would you like to enter the initial configuration dialog? YES
---------------------------------
Any help would be appreciated!
Thanks,
Greg.