CO Trunk wiring for Definity system

[steph4pbx]

Where are the punch downs for Lucent Definity system where the CO trunk go into the system? This would be for analog lines - not Tie or T1. I have two analog lines that I want to be able to call out from and have it ring on a station and am trying to figure out where the punch downs go as whoever installed didn't label it...
Thanks. What ports are these on anyway? I am an NEC guru for programming and wiring and the system is just not the same - haven't figured it out yet...

 

[AvayaTier3]

What is the circuit-pack type?

tn747B ?

Command: list config board 1a07 (example)
what port on what type board are you going to use for your
trunk?

http://support.avaya.com/edoc/docs/def7_1/d71itscc.pdf

Should be able to lookup wiring by searching link above for your circuit-pack

A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

35 years Bell, AT&T, Lucent, Avaya
Tier 3 for 25 years and counting

http://bshtele.com

 

[4merAvaya]

The attached link may be more specific.

Kevin

http://support.avaya.com/elmodocs2/comm_mgr/r4_0/avayadoc/03_300151_6/jobaids/245773_5.pdf

 

[AvayaTier3]

To be more specific, Kevin.

This pack has been around for 20 years

Table 5-36 on page 231 and 232

http://support.avaya.com/edoc/docs/def7_1/d71itscc.pdf

A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

35 years Bell, AT&T, Lucent, Avaya
Tier 3 for 25 years and counting

http://bshtele.com