CM 5.2 to Cisco call manager

[mikeydidit]

Good morning guys. It's been a while. I have Cisco in to do a test bed for us. I am trying to configure SIP trunks off an Old SES server to the Cisco and need some help with node names and the Signaling group. If you still have this setup in an old system and would be willing to post the config for me. I would most appreciate it.

Thanks
Mikeydidit

When is the last time you helped someone, just because you were able to?

For the best response to a question, read faq690-6594

 

[montyzummer]

You can do a direct trunk in the cisco there is no specific need to use SES , but what help do you require the local end in the sig will be a clan or procr and the far end will be whatever you have set up and assigned an ip address to in change node-names ip

APSS (SME)
ACSS (SME)
ACIS (UC)

 

[mikeydidit]

Well below is what I have now and the signaling group is up. (Cisco also shows to be up and active) The trunks are in service idle. But still getting a fast busy when dialing into either system. So I'm not sure what to check from here. Any ideas?

change signaling-group 10                                       Page   1 of   1
                                SIGNALING GROUP

 Group Number: 10             Group Type: sip
                        Transport Method: tcp
  IMS Enabled? n





   Near-end Node Name: Clan-01a05            Far-end Node Name: Crisco
 Near-end Listen Port: 5060                Far-end Listen Port: 5060
                                        Far-end Network Region: 4
Far-end Domain:

                                             Bypass If IP Threshold Exceeded? n
Incoming Dialog Loopbacks: eliminate                  RFC 3389 Comfort Noise? n
         DTMF over IP: rtp-payload            Direct IP-IP Audio Connections? y
Session Establishment Timer(min): 3                     IP Audio Hairpinning? n
         Enable Layer 3 Test? n                     Direct IP-IP Early Media? n
H.323 Station Outgoing Direct Media? n            Alternate Route Timer(sec): 6

When is the last time you helped someone, just because you were able to?

For the best response to a question, read faq690-6594

 

[montyzummer]

domain in network region maybe also fill in far end domain on the sig , can you attempt a call a list trace the station or tac and post the results

APSS (SME)
ACSS (SME)
ACIS (UC)