Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Clock Synchronization signal
- Thread starter Labash
- Start date
Did you set the sync source? If there is a DS1 in the G700, that should be set as the sync source. Use the commands set sync ? to see the command syntax. I don;t know how to do it via the web, I prefer to telnet into it.
If the sync source is not set properly, you will get dropped calls and other problems and these will get worse over time.
If the sync source is not set properly, you will get dropped calls and other problems and these will get worse over time.
Telnet or SSH into the G700's MGP IP address, login (root/root), then type in these commands:
"set sync interface primary v4" (if your MM710 is in slot V4)
"set sync source primary"
"show sync timing" (to see if is is now syncing of the DS1)
Mitch
AVAYA Certified Expert
"set sync interface primary v4" (if your MM710 is in slot V4)
"set sync source primary"
"show sync timing" (to see if is is now syncing of the DS1)
Mitch
AVAYA Certified Expert
- Thread starter
- #4
- Status
Similar threads
- Locked
- Question