CLID on PRI

[philcap]

Hi

I have a PRI trunk. I want that all calls going out/or routed this PRI will used the same CLID. Is this possible
How could I don it in the Option 11C. I'm using 24.X release.

thanks

 

[PERRYPJ]

CLICK ON FAQS AT THE TOP, THERE IS A SHORT EXPLANTATION

OLD ROLMEN WORKING ON NORTELS

 

[johnpoole]

if you want just the clid to be used on one route. make arrangements with the provider of that pri.. they put a number on in their office and discard your digits. if you build a clid table and add it after the dn's it will display on all outbound calls ..to build a clid table go to ld 15 chg net and at clid yes, the entry x, either a new a existing table.. if you want a single clid table for all (or most) of your stations, then make it entry 0, that is default for all phones...then make an entry x and use it for the exceptions at the set level. ld 11 key 0 scr 2323 5, would use entry 5 for that dn all calls to any pri route. for the rest of the lines on that phone, either use the default 0 (no change) or d , menaing the same as 0 or a different entry

john poole
bellsouth business
columbia,sc